Genie GU4TR2-P Remote

Your Genie GU4TR2-P at a glance

Four individually programmed buttons. Identify receiver protocol and remote software revision first.

GU4TR2-P battery & holder

One 3 V CR2032; loosen rear screw and open case. Preserve polarity.

Programming your GU4TR2-P

Setup depends on the exact receiver and hardware revision. These model notes do not establish a complete pairing sequence for your equipment.

Match both the remote and opener or external receiver. Keep the door or gate in sight and clear of people. Do not hold a LEARN button or erase memory unless the instructions for that exact equipment require it.

Compatibility & exclusions

Only documented receiver protocols; garage openers must be 1993 or newer with working photoelectric safety sensors.

Full compatibility table and alternate procedures not reproduced. No unsupported press counts.

If your GU4TR2-P is not working

Checks for GU4TR2-P

• Virtual DIP capability requires software v1.1.4+. Teach & Pair is limited to v1.1.8 or earlier; Marantec may disrupt existing devices, so escalate until version and receiver are confirmed.

General troubleshooting checks.

• No response: check the marked battery type and polarity; note whether another authorized control works.
• Short range: note when the problem began and whether it changes by location. Do not alter receiver wiring.
• Damaged case or buttons: keep the model label; stop using exposed, wet or damaged electronics.

GU4TR2-P repair, parts & replacement

No exact replacement or part mapping has been confirmed for this page. A similar-looking remote, matching frequency or familiar model family is not sufficient evidence of interchangeability.

Model guides

Use the model-specific notes on this page with the instructions for your opener or receiver. A documented receiver match does not establish compatibility with every opener.