Genie GU4T Remote

Your Genie GU4T at a glance

Four individually programmed buttons. Identify receiver protocol and remote software revision first.

GU4T battery & holder

One 3 V CR2032; loosen rear screw and open case. Preserve polarity.

Programming your GU4T

Setup depends on the exact receiver and hardware revision. These model notes do not establish a complete pairing sequence for your equipment.

Match both the remote and opener or external receiver. Keep the door or gate in sight and clear of people. Do not hold a LEARN button or erase memory unless the instructions for that exact equipment require it.

Compatibility & exclusions

Only documented receiver protocols; garage openers must be 1993 or newer with working photoelectric safety sensors.

Full compatibility table and alternate procedures not reproduced. No unsupported press counts.

If your GU4T is not working

Checks for GU4T

• Virtual DIP capability requires software v1.1.4+. Teach & Pair is limited to v1.1.8 or earlier; Marantec may disrupt existing devices, so escalate until version and receiver are confirmed.

General troubleshooting checks.

• No response: check the marked battery type and polarity; note whether another authorized control works.
• Short range: note when the problem began and whether it changes by location. Do not alter receiver wiring.
• Damaged case or buttons: keep the model label; stop using exposed, wet or damaged electronics.

GU4T repair, parts & replacement

No exact replacement or part mapping has been confirmed for this page. A similar-looking remote, matching frequency or familiar model family is not sufficient evidence of interchangeability.

Model guides

Use the model-specific notes on this page with the instructions for your opener or receiver. A documented receiver match does not establish compatibility with every opener.