Service / Troubleshooting / Help
Chamberlain 950-315CB remote control

Chamberlain / LiftMaster

Chamberlain 950-315CB Remote

Identify your exact Chamberlain 950-315CB remote before checking batteries, programming or replacement options.

Brand
Chamberlain
Exact model
950-315CB
Device type
Handheld remote
Product region
US

Your Chamberlain 950-315CB at a glance

Confirm the brand and the complete 950-315CB label, including any additional suffix or hardware revision. A similar case or shared model number does not establish an interchangeable remote.

950-315CB battery & holder

One 3 V 2032, positive side up; part 10A20.

Programming your 950-315CB

Setup depends on the exact receiver and hardware revision. These model notes do not establish a complete pairing sequence for your equipment.

Match both the remote and opener or external receiver. Keep the door or gate in sight and clear of people. Do not hold a LEARN button or erase memory unless the instructions for that exact equipment require it.

Model guidance →

Compatibility & exclusions

Exact manual specifies orange Learn Security+. Check full receiver model/frequency, not color alone.

Replacement remote equivalence is not verified.

If your 950-315CB is not working

General troubleshooting checks.

  • No response: check the marked battery type and polarity; note whether another authorized control works.
  • Short range: note when the problem began and whether it changes by location. Do not alter receiver wiring.
  • Damaged case or buttons: keep the model label; stop using exposed, wet or damaged electronics.
Work through the troubleshooting guide →

950-315CB repair, parts & replacement

No exact replacement or part mapping has been confirmed for this page. A similar-looking remote, matching frequency or familiar model family is not sufficient evidence of interchangeability.

Model guides

Use the model-specific notes on this page with the instructions for your opener or receiver. A documented receiver match does not establish compatibility with every opener.

Programming preparation →