LiftMaster 380UT Remote

Your LiftMaster 380UT at a glance

Two buttons, each programmed separately.

380UT battery & holder

One 3 V CR2032.

Programming your 380UT

Setup depends on the exact receiver and hardware revision. These model notes do not establish a complete pairing sequence for your equipment.

Match both the remote and opener or external receiver. Keep the door or gate in sight and clear of people. Do not hold a LEARN button or erase memory unless the instructions for that exact equipment require it.

Compatibility & exclusions

Supported Learn/DIP receivers only. Residential use requires openers made from January 1, 1993 with photoelectric safety sensors.

Universal does not mean every receiver. Identify the receiver before selecting a press count; no blanket replacement equivalence is verified.

If your 380UT is not working

Checks for 380UT

• With supported two-position DIP receivers, failed matching may require reversing the remote ON/OFF pattern as specified by the manual.

General troubleshooting checks.

• No response: check the marked battery type and polarity; note whether another authorized control works.
• Short range: note when the problem began and whether it changes by location. Do not alter receiver wiring.
• Damaged case or buttons: keep the model label; stop using exposed, wet or damaged electronics.

380UT repair, parts & replacement

No exact replacement or part mapping has been confirmed for this page. A similar-looking remote, matching frequency or familiar model family is not sufficient evidence of interchangeability.

Model guides

Use the model-specific notes on this page with the instructions for your opener or receiver. A documented receiver match does not establish compatibility with every opener.